FA  

|  

EN

Flexible topcoat for low density PU foam

WATERBASED LACQUER FOR FURNITURE

BRAND:

PRODUCT CODE:YO 10M591 / NTR

MAIN PROPERTIES:

– Excellent elasticity and touch feeling -Excellent sheen level uniformity
– Can be pigmented -Excellent resistance against deforming

VERSIONS:

10M591/ NTR 10 gloss

RECOMMENDED USE:

– For substrates highly
deformable

APPLICATION METHOD:

Spray: airmix, airless, spray gun, . Electrostatic guns may be used provided they are suitable for
waterborne products

BLENDING INSTRUCTIONS:

ready to use; for spray gun application, thinning with tap water at 5-15%

CHEMICAL-PHYSICAL CHARACTERISTICS(23 °C)

Solid contents (%) 24 ± 1 
Specific gravity (g/cm3) 0,82 ± 0,020 
Viscosity G5 V10 22000 ± 3000 cps 
Viscosity Brookfield (mPas) – 
pH 8 – 8,5

APPLICATION PROPERTIES:

Vertical application (μm wet) 250
 Recommended n° of coats 1
 Recommended application   weight (g/m2)
min: 150 max: 250
 Interval between coats   –                                                       Spreading rate (m2/liter)

SUBSTRATE PREPARATION:

substate must be carefully cleaned, removing all traces of greas, oil or waxes. YO 10M591/NTR can be applied on a wide range of
PU foams if previously treated with basecoat YL M590/–NTR we recommend to check quantity to be applied as well as overcoating
time to grant better adhesion . Application of topcoat YO 10M591/NTR directly on PU foam is not recommended as it does not grant
same elasticity and adhesion performances that it can be obtained by applying previously basecoat YL—M590/–NTR.
Pigmented pastes of series EY—M460/XX or EY—M500/XX can be added at a ratio of 4% -8%

GENERAL REMARKS:

– Mix well before use.
– If properly stored at temperatures between 5 and 35°C, shelf life is 12 months
– Never apply at temperature below 15°c.
– Coatings applied at lower temperatures will show chemical and mechanical properties lower than standard performances that
can be normally achieved.
– Coating left over (washing waters, waters from spray booths, used coatings) must be disposed of according to local regulations.
Never dispose residues directly into drains.
– Application tools must be cleaned with water after use. When dry films must be removed, AY—M460, special detergent should
be used, letting it work overnight and then cleansing with water

DOWNLOADS:

ORDER THIS PRODUCT:

Flexible topcoat for low density PU foam

برند:

کد محصول:YO 10M591 / NTR

دانلود:

سفارش این محصول: